Equipment introduction:

The steam-heated high-temperature double-layer sterilization pot adopts advanced technology, using hot water circulation and immersion sterilization. During the sterilization process, the circulating water in the sterilization tank is continuously switched from up, down, left and right, ensuring the inside of the tank From heating, keeping warm and cooling, the heat distribution at any point is uniform, and the dead angle phenomenon in the effective sterilization process makes the shelf life of the product more stable.

The steam-heated high-temperature double-layer sterilization pot uses steam in the hot pool to raise the water temperature to boiling, and starts the water pump to pump the hot water into the pot with a large-diameter flow pipe for direct sterilization. When the hot water reaches the water level, immediately start the hot water circulation pump to circulate the hot water in the pot, adopting the method of three points for water out and eight points for water in. When circulating, in order to ensure the evenness of the water point in the pot, three points are used. Tandem type. Circulating water quickly heats up through water vapor exchange (using this water vapor exchange to avoid direct contact between steam and cargo when heating in the pot, which makes some cargoes high in temperature), and then passes through eight water inlet points in the pot (above , Bottom, left and right points) to make the hot water directly reach the sterilization pot for circulation. While the hot water in the pot circulates, the steam angle seat valve automatically opens to raise the temperature in the pot. When the temperature is about to be reached, pass The temperature transmitter accurately conveys the temperature in the pot to the temperature controller, and controls the steam angle seat valve to adjust the temperature. This regulating valve is gradually adjusted according to the rise and fall of the temperature in the pot to prevent the temperature from backlash when the pot reaches the temperature. . When the set temperature is reached, close the steam angle seat valve and enter the product sterilization stage (different product sterilization time can be adjusted). When the sterilization time is reached, the alarm will alarm, open the water outlet valve and the water pump, and pump the hot water in the pot to the hot water pool, which will be recycled for the next pot sterilization.